View Full Version : Hub nut size
Anyone know the size of the hub nut on the front?
novarally
20-08-10, 09:06 AM
30mm.
you will need a deep socket mate...
you will need a deep socket mate...
No you wont - unless its got XE shafts.... The Nova CV joints are quite short/shallow - I have managed hundreds with a trusty 'normal' depth socket.
mk1nova_rich
20-08-10, 05:05 PM
Halfords sell them for around £6 and are good enough quality
MARTIN KELSON
20-08-10, 08:52 PM
Sorry to hijack your thread.
Once you have undone the nut is the hub/flange pressed into the bearing or can you slide hub of the shaft & out.
Need to swap my hubs over soon & not sure if its a diy job or take to garage?
Martin
Swapping hubs is easy enough
undo balle joint track rod end and strut
Undo the hub nut and pull off the hub easy peasy lol
MARTIN KELSON
20-08-10, 08:57 PM
Pressed in mate,
Thanks mate.
Not a diy job then :(
I just take the hub to a local garage and get them to do the bearings aswell, usually £20 covers it to be done in 10 mins.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.