philip
11-08-10, 10:39 AM
im looking at selling my 20xe. spec as follows:
bottom end:
Steel rods
CP flat top slipper pistons 88mm
ARP rod bolts, flywheel bolts and main studs
Early unground crank
lightened steel flywheel
Helix 4 paddle clutch
single V pulley
new oil pump with SBD Steel inner gear
ACL heavy duty bearings
full balance
Head:
Later dispac casting
match ported/polished, cut back guides into ports
3angle seats
REC wasted valves(stock size)
Colsibro guides
piper double valve springs
steel caps
Arrow solid lifters
Newman full race cams
piper round tooth verniers
SBS head stud kit with ARP nuts.
1.3mm cometic headgasket
Induction:
QED DTH throttle bodies with 45mm trumpets(drilled for nitrous injectors) with C20LET injectors
Exhaust:
Tony law exhausts manifold 4-2-1 - no system
Engine can come with receipt for all the work...i have reciepts for most of the parts but i can also write one for whole lot.
Engine was built with OEM elring gasket sets, ACL bearings, new water pump full gates belt kit. numerous parts bought for it with receipts.
Engine has NEVER ran since being built as i am still building the car.
can email pictures of all the components/work done to genuine people.
not added up all the costs, but i know an engine this spec would set up back close £8-9k to have built.
£6000 ono
motor was built for a genuine 260+bhp
phil 07807 040522
*will get pics up over weekend of parts/build*
bottom end:
Steel rods
CP flat top slipper pistons 88mm
ARP rod bolts, flywheel bolts and main studs
Early unground crank
lightened steel flywheel
Helix 4 paddle clutch
single V pulley
new oil pump with SBD Steel inner gear
ACL heavy duty bearings
full balance
Head:
Later dispac casting
match ported/polished, cut back guides into ports
3angle seats
REC wasted valves(stock size)
Colsibro guides
piper double valve springs
steel caps
Arrow solid lifters
Newman full race cams
piper round tooth verniers
SBS head stud kit with ARP nuts.
1.3mm cometic headgasket
Induction:
QED DTH throttle bodies with 45mm trumpets(drilled for nitrous injectors) with C20LET injectors
Exhaust:
Tony law exhausts manifold 4-2-1 - no system
Engine can come with receipt for all the work...i have reciepts for most of the parts but i can also write one for whole lot.
Engine was built with OEM elring gasket sets, ACL bearings, new water pump full gates belt kit. numerous parts bought for it with receipts.
Engine has NEVER ran since being built as i am still building the car.
can email pictures of all the components/work done to genuine people.
not added up all the costs, but i know an engine this spec would set up back close £8-9k to have built.
£6000 ono
motor was built for a genuine 260+bhp
phil 07807 040522
*will get pics up over weekend of parts/build*