View Full Version : Digi Dash
Lewis.heard
02-08-10, 09:39 AM
I've seen loads of astra gte digi dashes put in Mk2 nova's
Will it fit into a mk1 nova dash? and if so do i have to do anything to the digi dash or my mk1 dash?
also if you have any pics then could you post them please :)
you will have to chop the dash to get it to fit, then of course wiring it up
yup you need to cut aalot out of the dash.
Lewis.heard
02-08-10, 10:03 AM
oh right, where abouts on the dash do i need to cut apart. is it worth me bothering with it? i do think it would look good in a MK1 dash.
the wireing bit ain't a problem for me though, thats easy enough.
iirc you need to make the hole bigger where the clocks go
look at the hole, you need to slice it along the edges so it opens outwards.
Lewis.heard
02-08-10, 10:38 AM
oh right ok, so get a stanly knife of something and slice the edges of the whole till they are bigger, do i need to do it all the way round the whole or just on the tops and sides? then once i've done that the it should just pop in?
do i need to put anything in the dash to keep the digi in place or will it just stay there?
Lewis.heard
02-08-10, 10:43 AM
oh right ok, so can i do that with just a stanly knife or something? do i cut back all of the edges or just the top and sides?
once ive done that will the digi just stay in place or do i have to put brakets in or something for it to stay in place??
theres a guide in there fella
http://www.pngclub.com/forum/showthread.php?t=77753
Lewis.heard
02-08-10, 11:00 AM
cheers mate
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.