ST-eater
01-08-10, 08:34 PM
I've fully rebuilt an xe and tried starting it up today. To cut a long story short it runs great but there is oil p*ssing out of the seal that's on the crankshaft (the one that sits in the oil pump).
This was replaced on the rebuild, but upon removing it, the seal looks worse for wear.
Are these a standard size and is there a special way to refit them? As there is a spacer for the pully, not sure wether to fit this first or not.
Do I use any sealant?
This was replaced on the rebuild, but upon removing it, the seal looks worse for wear.
Are these a standard size and is there a special way to refit them? As there is a spacer for the pully, not sure wether to fit this first or not.
Do I use any sealant?