frank_dh
28-07-10, 09:13 PM
Guys,
Sure you've seen this one 10,000 times before but I've lost my Haynes and can't remember!
For set up, I know about putting in a 5mm drill bit in the selector housing, my only query is where my mate needs to hold the gear shift while I clamp it up?
Is it in line with the reverse gate, pushed down and slammed over? Also do I really need to remove the centre console for this?
My mate doesn't have long tomorrow so I need to know what I'm doing - ish!
I know its been on here loads but searched and can't find the info.
Any help greatly appreciated as always, Frank
Sure you've seen this one 10,000 times before but I've lost my Haynes and can't remember!
For set up, I know about putting in a 5mm drill bit in the selector housing, my only query is where my mate needs to hold the gear shift while I clamp it up?
Is it in line with the reverse gate, pushed down and slammed over? Also do I really need to remove the centre console for this?
My mate doesn't have long tomorrow so I need to know what I'm doing - ish!
I know its been on here loads but searched and can't find the info.
Any help greatly appreciated as always, Frank