F28 and equal lenght set up?

[bazil]

Right thanks to David dixon I have the 2 shafts for the equal lenght set up, in a local scrappy there are 2 calibras with the setup, do I only need the gearbox to mount shaft and the engine block mount? Or is it best to get all 3 shafts and cv's

secondly would these inner cv's fit the F28?

( it's my first big block engine and box set up, so I don't know jack shoite)

[Lee H]

You need the inner cv that goes on the drivers side outer shaft as it's a female cv joint rather than a male one. I'd get the lot and you can then use the outer cv's on your Nova shafts and just bin the two Calibra outer shafts.

[bazil]

Thanks Lee :)