PDA

View Full Version : Xe rocker cover bolt torque please


John
12-07-10, 08:08 PM
As per title :)
Adam
12-07-10, 08:10 PM
Something stupid low like 8lb/ft
AlexW
12-07-10, 08:14 PM
As ad said iirc.

Be careful with them as you might not get to that before they snap.
Lee
12-07-10, 08:28 PM
As per title :)

For what car?
















..... roffle
John
12-07-10, 08:29 PM
pmsl lol
Benn
12-07-10, 08:52 PM
Just tight in enough...
Stuart
12-07-10, 09:26 PM
FT lol
16v Nova Kev
12-07-10, 09:43 PM
just before hs.
John
12-07-10, 09:57 PM
lol, so does anyone have the actual torque in nm?
16v Nova Kev
12-07-10, 10:20 PM
Cylinder head instructions Cylinder head
Renew bolts Yes Stage 1 Tighten 25 Nm Stage 2 Tighten 90° Stage 3 Tighten 90° Stage 4 Tighten 90° Other tightening torques
Main bearings Renew bolts/nuts Yes Main bearings Stage 1 50 Nm Main bearings Stage 2 45°-60° Big end bearings Renew bolts/nuts Yes Big end bearings Stage 1 35 Nm Big end bearings Stage 2 45°-60° Oil pump to cylinder block 6 Nm Sump bolts 15 Nm Sump drain bolt 55 Nm 11 Flywheel/driveplate Clutch to flywheel 15 Nm 42 Crankshaft pulley/damper 69 Camshaft sprocket/gear 68 Camshaft carrier/cap Camshaft/rocker cover 8 Nm Inlet manifold to cylinder head 22 Nm Exhaust manifold to cylinder head 22 Nm Spark plugs 25 Nm Oxygen sensor (Lambda) 30 Nm 8 Front hub Manufacturer: Vauxhall/Opel Model: Vectra-A/Cavalier 2,0 16V Engine code: C20XE Output: 110 (150) 6000 Tuned for: R-Cat Year: 1990-94
© Autodata Limited 2004 15/05/2009 V5.373-

as above 8nm