View Full Version : basted motor factors/gasket manufacturer
first off at the nats day i had a blowing exhaust manifold.... i snapped a stud off when i fixed that, but soldiered on.......
then i blew my head gasket.... and ordered a payen gasket set for an E16SE from my local decent motor factors..
and i pulled my engine apart this morning to fit my other head & also do all those jobs i've been meaning to do, like cambelt, water pump, and a tidy up for billing.
and the sodding inlet gasket is SQUARE!!!!!!!!!!!!!! i have a drive full of bits!!!
and i can't put it back together... i can't cut the gasket because it is completely different & there would be bits missing......
there, rant over..... i needed to tell it to someone who understood what i was angry about.... the missus & kids neither know or care
Nova_Sean
04-07-10, 09:09 PM
missus and kids in a nice big bbq smothered in levi roots reggae reggae ftw
General Baxter
04-07-10, 09:16 PM
what shape gasket inlet ?
nick, round i'm guessing lol lol
cornflakes packet ftw mike. tap round ports with ball end of ball pein hammer for instant correct shape gaskets.
Almost all E16SE gasket sets have the wrong inlet gasket, the only way to get a right one is some sort of Astra 1.6 iirc
General Baxter
04-07-10, 09:18 PM
i dont know, crappy small blocks lol
making gaskets FTW :)
Almost all E16SE gasket sets have the wrong inlet gasket, the only way to get a right one is some sort of Astra 1.6 iirc
I had the same problem :( I resorted to having to buy an inlet gasket from Vauxhall as my local motorfactor women refused to believe her "book 'O' gaskets" was wrong :wtf:
i looked round the cupboards & the cardboard bin, and there isn't a box big enough..... but i need the right one.....
i'd even get a gm one if someone can give me the part number
silicone would be easier lol lol
i looked round the cupboards & the cardboard bin, and there isn't a box big enough..... but i need the right one.....
i'd even get a gm one if someone can give me the part number
:( not got a part number im afraid
Altho, GM parts guys should easily be able to sort it for you :) the parts guy (Rich) at Brindley in Cannock used to have a few Nova;s so he knew the score when I asked him like lol
dan, i still like the reassurance of a piece of gasket paper for reliability
i'm planning to have a pop at the motor factor first, then take it from there
90571863 is the part number. Prob be about £10, and usualy made by earling, or however its spelt.
its elring, ta for the number
Thats it! Couldnt remember the spelling, but knew what i ment lol
right, the round inlet gasket is Payen part no. jc823, it is about £2.50+vat
so I have one more problem, the bottom hose I asked for came in as Gates 3516... it is not going to fit my car..
i bought a 1.6 rad off JohnH & the bottom outlet is a couple of inches higher up than on my old one, which was a 1983 1.2 full height rad, and the gates hose looks like it is a perfect fit for that...
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.