still holding back URGENT

[davidfox280585]

well powercap on proper filter everything as should be

its idling fine and revving up fine just majorly holding back stuck as what to try next maybe a set of new plugs,
anyone know which plug number they are as i think they could be wrong

MOT IS DUE AND WANT IT RUNNING RIGHT:thumb:

[djbrowney]

incorrectly gapped plugs
fooked plugs
fooked leads
fooked rota arm
fooked dizzy cap
fooked crank sensor
fooked lambda sensor

lol

[General Baxter]

incorrectly gapped plugs
fooked plugs
fooked leads
fooked rota arm
fooked dizzy cap
fooked crank sensor
fooked lambda sensor

lol

water temp sensor,
or just a **** engine lol

[Benn]

Cts.

[edens-xe]

is it doing it when its warm or when cold? poss temp sensor. but then again what engine is it?

edit redtop just seen your wip thread, but yeh as above aswell there always the usual suspects. ive had a couple or rotor arms snap on me before and wobbling all over the show causing crap performance(cheap rotor arms ftwlol)

[davidfox280585]

its all the time,
just swapped the knock sensor and idle control valve plugs to see if i got them wrong same with either,

tomorrows job is plugs and leads and cts and see where we are,

just swapped air mass sensor with my mates xe which runs perfect and no difference

[djbrowney]

leads dizzy rotor

[davidfox280585]

leads dizzy rotor

yes its c20xe on dizzy,
ive removed all the dizzy and that seems fine though im not happy with the plug leads so will change tomorrow along with plugs and cts

[General Baxter]

lob a compression tester on it lol

[davidfox280585]

lob a compression tester on it lol
was running perfect in he calibra as i made sure all was ok before it came out

[krobinson]

I'd try Lambda!

[davidfox280585]

well after getting mad took it out straight from cold and give it some stick and it went properly but then started to hesitate as it got a bit warmer will try leads plugs and cts tomorrow see how i go