View Full Version : how ?
bmxalex
13-06-10, 08:37 PM
how have some of you mounted your gsi skirts ??
get the oe clips and rivet them on.
bmxalex
13-06-10, 08:48 PM
???
???
What dont you understand ?
bmxalex
13-06-10, 08:55 PM
is there any other way with out drilling the body ??
Adhesive such as sikaflex.
bmxalex
13-06-10, 09:09 PM
i just dont want too drill my arch screw lol
General Baxter
13-06-10, 09:11 PM
do it proper or not at all lol
bmxalex
13-06-10, 09:13 PM
il screw it **** it lol
craig green
13-06-10, 09:20 PM
do it proper or not at all lol
In all fairness, if I wasnt sure if they would be on forever, I certainly wouldnt pepper my sills in holes.
bmxalex
13-06-10, 09:32 PM
yeah thats what i was thinking too
16v Nova Kev
13-06-10, 11:04 PM
holes in sills = rot so i would stick them on properly.
tiger seal :thumb:
ftw the best stuff ever invented
16v Nova Kev
14-06-10, 10:38 AM
i would go for wurth seal fix.
bmxalex
14-06-10, 07:42 PM
So How Should They Be Put On ?? How Did Vauxhalls Do It ??
bmxalex
14-06-10, 09:30 PM
can someone help plaese is there clips i need to get or do i drill and screw ??? cheeers
Southie
14-06-10, 09:53 PM
Usually the clips were drilled/clipped in. If your not wanting to do this then sikaflex or tigerseal is your only option or you could just sell them ;)
nova_saloon
14-06-10, 09:57 PM
gaffa tape. i see this on so many cars, has so many uses, covering up rust, holding on bumpers repairs snapped wing mirrors, ive seen all this done, and when done right, is hardly noticeable. lol
bmxalex
14-06-10, 10:00 PM
i just dont want to drill throgh the sill and make it rust
General Baxter
14-06-10, 10:25 PM
just a note, tiger seal, dont like the heat, note my rub strips on the 5 door at nats ;)
timbo1980
14-06-10, 10:44 PM
Drill hole & blind pop rivets, slide clip over rivet, you could paint the holes after you drill holes,The pop rivets are about 25p each fom vauxhall
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.