phunkynova
13-06-10, 07:11 PM
1st question is if look at the 1st 2 photos would you say that this could be a problem ?.As my cooling system has been pressurized so much that the water is blown out.
2nd question is is it possible to grind a 1.4 head with square ports to mach a 1.6 round inlet manifold ?. also photo to show what I talking about.;)http://i995.photobucket.com/albums/af71/phunkferret/MyNovarallycrosscar133.jpghttp://i995.photobucket.com/albums/af71/phunkferret/MyNovarallycrosscar134.jpghttp://i995.photobucket.com/albums/af71/phunkferret/MyNovarallycrosscar131.jpghttp://i995.photobucket.com/albums/af71/phunkferret/MyNovarallycrosscar132.jpg
2nd question is is it possible to grind a 1.4 head with square ports to mach a 1.6 round inlet manifold ?. also photo to show what I talking about.;)http://i995.photobucket.com/albums/af71/phunkferret/MyNovarallycrosscar133.jpghttp://i995.photobucket.com/albums/af71/phunkferret/MyNovarallycrosscar134.jpghttp://i995.photobucket.com/albums/af71/phunkferret/MyNovarallycrosscar131.jpghttp://i995.photobucket.com/albums/af71/phunkferret/MyNovarallycrosscar132.jpg