c20xe

[2.0 nova paul]

were dose the idle controll go on a c20xe

and has any one got what plugs go were on the engine

[djshaggeh]

ICV is underneath the inlet manifold iirc.

[w88rdy]

icv and knock sensor are under the inlet manifold, they normally has its own loom tbh

[2.0 nova paul]

i think i have found the plug but were gose the idle controll go on to

[comptoncj]

Its under the inlet manifold with two pipes on it that go to the sfi box early xe's dont have a seperate loom but should disappear about half way down the fuel rail. along with a red plug for the knock sensor.

[2.0 nova paul]

dose any 1 know were these go ont he bear box side on the same bit of loom with the plug what gose to the dizzy cap

http://i493.photobucket.com/albums/rr291/paullewis89/P100610_2038_01.jpg

inside of the plug

http://i493.photobucket.com/albums/rr291/paullewis89/P100610_2038.jpg

[comptoncj]

four pin one is coil

[2.0 nova paul]

i need to get a coil pack lol somthin elce to add to my list then coz the 1 i have on my 2.0 8v only has 2 pins dose any 1 know wot the other 1 dose

[comptoncj]

Just a word of advice cut the text speak out so people can understand lol, the other one looks like the oil pressure switch plug but i didn't think that was on that loom.

[2.0 nova paul]

sorry about the typing lol there is the same plug at the back of the engine what i have plugged in to the oil pressure i thort the same as u have when i looked at it

[comptoncj]

Im sure this question came up with someone fitting a c16se into a nova. maybe worth searching.

[2.0 nova paul]

i am just puting the loom on the engine befor i put it in as when i picked the engine up to day it was allready off the engine