View Full Version : Harness fitting point issue?
Ive got some bucket seats with runners and im going to make my own sub frames using the 2 bar method everyone seems to use on here. But if i do that the harness point where your seatbelt would usually clip into? Is obviously gone. Any ideas?
mk1nova_rich
29-05-10, 02:06 PM
use the proper FIA-spec eyebolt mounting plates welded into the shell. Then you can position them properly rather than making do with existing mounting locations.
napalm_27
29-05-10, 02:11 PM
i drilled a hole in the exhaust tunnel behind the handbrake and put a bolt through the harness hole and bolted it to the floor and then used the metal rail bolt hole for the standard seat belt to do the other side
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.