View Full Version : how to connect adjustable fuel pressure regulator
how do i connect up my cossie fuel pressure regulator? I also have a gauge that i want to connect.
i have the 2 fuel supply lines, one goes to pass side of fuel rail.
other goes to drivers side of fuel rail where the standard regulator is. I have the blanking piece in place but am unsure how to connect up
think i have it??
the fuel line comes from tank, into the bottom of the cossie regulator, then outwards into the fuel rail?
on the rail where i have the blanking plate, as pictured here:
http://www.max-boost.co.uk/max-boost/images/LET/fuelling_ignition_cooling/FPR_blank_sm.jpg
the take off on there, is that for the gauge?
GRUNT 16V
14-05-10, 02:01 PM
Yes What You Do Is Attach The Vacume Line To One End! Then Start Swinging It Around (olympics Hammer Styleeee) Then Let It Go At The Correct Moment !!! If Your Lucky It, Will End Up In A Bin Where You It Will Not Cause You Any Trouble
Job Done !!!!!!!
On A Serious Note They A Kack!
what are kack?
its not a crappy fse jobby?
its a cossie webber one?
GRUNT 16V
14-05-10, 02:03 PM
ooooooooo did not relise
lol
so is what i said correct?
dont fancy upping the boost without it getting correcto fueling
Yes What You Do Is Attach The Vacume Line To One End! Then Start Swinging It Around (olympics Hammer Styleeee) Then Let It Go At The Correct Moment !!! If Your Lucky It, Will End Up In A Bin Where You It Will Not Cause You Any Trouble
Job Done !!!!!!!
On A Serious Note They A Kack!
sorry, but this is killing me.....lol lol lol lol lol lol lol lol
all i can picture is this:
http://visualrian.com/storage/PreviewWM/3242/91/324291.jpg
now there's a girl who can piss up a lamp post
GRUNT 16V
14-05-10, 03:03 PM
shes bigger than jack !!!!!!!!!!
GRUNT 16V
14-05-10, 03:05 PM
just noticed that she must be desperate for a man !!!!!!!!! i mean wearing number 69 does seem a bit suspect
she is a giver, not a taker...........
she would turn you over and make you bite pillow........
aslong as it was duck feather...
want to share a tent pv?
lol
i think i'd better not, seeing as i'm not going
When you have fitted the blanking plate nothing comes out of the standard fuel return on the rail. You go from the blanking plate to the cossie reg and then from the bottom of the cossie reg back to the tank.
I have fitted my pressure gauge inline on the fuel feed line.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.