View Full Version : fitting 60/40 rear seats
mk1nova_rich
09-05-10, 10:09 PM
where can i get the two brackets to go in the middle - the ones that the seats "hinge" on?? are they available to bolt on or would i have to cut some out and weld them in?
colebag
09-05-10, 10:26 PM
i made mine my self mate you can prob buy a proper plate tho
craig green
09-05-10, 10:28 PM
Cut them out of a scrapped car, drill out the spot welds.
Theres usuallly plenty of people killing good shells for stripped track cars.
remember this...... your fuel tank is right below the rear seat floor.
when i did this, i cut the bits from a scrap shell, then carefully drilled & pop riveted them in place. the seats fitted fine.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.