How to roll arches??

[novaboy1.2]

Whats the best way of doing it? :roll:

I've put 15" momo arrows on and their just rubbing on the back arches when going around corners with 2 in the back. :evil:

Cheers :lol:

[cr2ig]

i had same problem but i grinded the little lip things inside the back archers and now there fine. cant get full lock on tho its about half a turn away! how do u sort tht?

[mikeoxford]

i had same problem but i grinded the little lip things inside the back archers and now there fine. cant get full lock on tho its about half a turn away! how do u sort tht?

get narrower alloys LOL

[Nova-Boy]

When you grind the lip off they may start to rust much more. You caould try to bend then up slightly with rolling a brrom handle or something but if your bodywork id good they pay to get it done by the pros.

My arches were going rusty so i cut them right off and and in the process of fibreglassing some new edges to stop water getting up between the sheets.

[Benjoyce]

wheel off, rubber hammer, bang bang bang!! there rolled arches.

[James B]

yer i did the rubber hammer trick too

[Jim]

Strip out your rear seats so you don't have two in the back ;)

Personnaly I'd take it to a bodyshop. If you feel confident enough to roll them yourself, go for it.

Jim