chappers1.3
14-04-10, 01:04 PM
1.8e Cylinder head from the mk1 astra.. Has had all the valves re-lapped, new stem seals and fully decoked, mildly ported all by my fair hands.
I cut the manifold down and skimmed the faceplate flat, then matched the inlet to the head, as was doing a self build R1 carb conversion manifold. its still in the same state, a few more bits of filling and then weld her up and you'll be there. All of this is build can be seen at:
Building your own inlet manifold - R1 Bike Carbs (http://www.migweb.co.uk/forums/projects-restorations/360480-building-your-own-inlet-manifold-r1-bike-carbs.html)
Didnt think i had done that good a job, but with over 5500 views i must have done well... glad it was of use to you all. http://www.migweb.co.uk/forums/images/smilies/smile.gif
I have all the bits req'd needing to finish the manifold... £35 collected from preston for the lot - can ship if req'd.
F28 front gearbox mount - £15 posted
they are the last few bits in the garage from my vauxhall loving days. Good Times they were too..
Also advertised on migweb.. just spreading the love...
I cut the manifold down and skimmed the faceplate flat, then matched the inlet to the head, as was doing a self build R1 carb conversion manifold. its still in the same state, a few more bits of filling and then weld her up and you'll be there. All of this is build can be seen at:
Building your own inlet manifold - R1 Bike Carbs (http://www.migweb.co.uk/forums/projects-restorations/360480-building-your-own-inlet-manifold-r1-bike-carbs.html)
Didnt think i had done that good a job, but with over 5500 views i must have done well... glad it was of use to you all. http://www.migweb.co.uk/forums/images/smilies/smile.gif
I have all the bits req'd needing to finish the manifold... £35 collected from preston for the lot - can ship if req'd.
F28 front gearbox mount - £15 posted
they are the last few bits in the garage from my vauxhall loving days. Good Times they were too..
Also advertised on migweb.. just spreading the love...