View Full Version : C14NZ... Turbo??
nova-taken
13-04-10, 10:43 PM
Hey guy,
im thinking about turboing my C14NZ, but have never done anything like this before, what would i need to do/ get (other than obviously a manifold and turbo) in order to get the job done to a good standard???
Cheers.
Rhyd :thumb:
1.6 mpi head, 1.6 mpi inlet manifold + injectors +TB etc.
Some sort of turbo manifold
intercooler/chargecooler
some sort of management to run it all
voila done.
nova-taken
13-04-10, 11:12 PM
That sounds incredibly simples,
thought it was more technical than that lol
its not that much more techical, but people seem to faff and screw it up by trying to use bodge/pikey stuff
the key to any good turbo set-up is proper management
Out of intrest how long would you expect these engines to last when there done properly?
Always been curious.
As long as any other engine - key word is PROPERLY - low comp pistons for example, not a pikey decompression plate... ;)
dj_wudgey
14-04-10, 11:43 AM
it doe's ot sound too hard to do!! and damen if done properly should last like any other engine!!
Buy saying that its always pikey engines that live forever lol
Buy saying that its always pikey engines that live forever lol
True lol true
Oh aye, sounds piece of pish alright. Until you need to make a turbo manifold lol
Well, my 1.4 spi motor built in my mums kitchen with a chemical metal'd inlet made 86bhp.... lol
Near 30bhp gain for about £130 aint too shabby.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.