View Full Version : exhaust wrap?
yayoboy
30-03-10, 11:06 PM
im planning on wrapping my type c manifold, would have it ceramic coated but im going to nurburg the end of next month and havent got the time to wait. but.... on looking on the net to find out 'techniques' to wrap it, found quite a few people saying that its dangerous, and they would never fit it as its a 'accident waiting to happen' due to it catching fire (gaps in the wrap or something) any opinions/experience, cheers, sean
youre meant to treat them with an oil resistant coating or something
if fitted properly its not a problem.
soak it in water, wrap with 1/4-1/2 width overlap minimum, keep it tight, wear a mask, either use jubilee clips at the ends/key points or wrap with mig wire tightly too.
I also recommend the EVIL paint you can get to go ontop of the wrap to give it extra life span etc.
yayoboy
30-03-10, 11:14 PM
ok, cheers. whats this paint your on about stu, and this oil resistant stuff paul?
it was in the exhaust wrap section of the DT catalogue
http://89.206.185.119/Store/Motorsport/Car_Preparation/Heat_Shielding_&_Protection/CoolIt_Hi_Heat_Coating/1471/2045
http://89.206.185.119/Store/Motorsport/Car_Preparation/Heat_Shielding_&_Protection/Design_Engineering_High_Temperature_Silicone_Coati ng/1471/1985
yayoboy
30-03-10, 11:43 PM
cheers for that stu
just dont breathe when spraying it!!!! even with a 2K filter on a mask I could still smell the vapours lol
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.