more e16 loom pics

[stevie78]

Help need to know what these wires are for as thats all i have left to wire
The blue with the yellow trace is comin out the car loom.

Not got a clue about the plug only space i have is on the oil presure swith but i dont think its ment to go there.

On the back of the block under the inlet i have a black conector sticking out any ideas its got two wire coming from it where do they wire to

thanks stevie


http://i140.photobucket.com/albums/r1/stevieg_03/novawires010.jpg (http://s140.photobucket.com/albums/r1/stevieg_03/?action=view&current=novawires010.jpg)
http://i140.photobucket.com/albums/r1/stevieg_03/novawires012.jpg (http://s140.photobucket.com/albums/r1/stevieg_03/?action=view&current=novawires012.jpg)

[stevie78]

ttt

[Sloth]

blue/yellow is volts feed to dash or back of alt. 2 pin is usually a sensor on the end of the mainfold...

[Cheeze]

Stevie, depending what engine was in your car originally you may still have a lot of wires for the engine that was in.

It was a SRi wasn't it? im sure these had the ecu under the dash behind the glovebox and the engine loom was wired in amoung the car loom, where as the gte and gsi has a seperate engine loom if you follow me.

so depending if your original ecu is in place you may have a heap of wires left from it.

Usually all you need from the old loom is a
blue/white tracer for your alt
blue for your water temp on dash
black/red for starter motor
blue/yellow i think for the oil pressure light

There might be one i have missed but im sure someone will correct me
blue/green for oil pressure guage

[stevie78]

yes m8 it is sri and the ecu was ripped out years ago.i have wired all the wires from the plug on the old e16 engine loom .(ur old one)straight on to the car loom am getin a spark and fuel but will not fire.belt mat have not been tight enough oops .just wantin to know what the wires left over are for.

theres a plug on the back of the block under the inlet almost dead centre you know what that is ?

[Adam]

Blue/yellow is oil pressure.
Blue/White is alternator

[stevie78]

is the oil presure swith the round thing right at the bottom just above sump gasket.
if so does the yellow and blue go in the space where the plug fits as i dnt have the plug or on the small pin like thing sticking out the oil presure swith

[vaughanmc]

Aye mate that's the Oil Pressure Switch - On yours it should have 2 pins but can't remember what colours go to them...