View Full Version : Cutting ABS plastic
mk1nova_rich
15-03-10, 12:41 PM
Whats the best way of cutting 3mm ABS to avoid shattering it?
Also try a hot knife, hacksaw etc. Depends what part and how much you're cutting IMO.
General Baxter
15-03-10, 12:53 PM
9" grinder ?
IME ABS melts and becomes a pain in the ass if you use anything like a saw with speed (even a handsaw can melt the stuff lol)
mk1nova_rich
15-03-10, 12:55 PM
got some 250mm width ABS need to cut it to length for a dash panel
IME ABS melts and becomes a pain in the ass if you use anything like a saw with speed (even a handsaw can melt the stuff lol)
I'm slow though, so not enough friction builds up. lol
i just thought if he was cutting a section out and then reshaping with sandpaper, file etc it may save some hassle.
you can get plastic cutting blades for jigsaws
mk1nova_rich
15-03-10, 01:27 PM
ok thanks, will get some of them jigsaw blades
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.