View Full Version : Unknown plug and wire
Hi,
Put the engine loom back in the car, and there is 1 plug and 1 wire left over, and I dont know what they go to.
The similar plugs that I have plugged in are:- oil switch, dizzy, idle control, coil, and the one on the dircet other side to the throttle cable.
I think the blue spade connector came from something under the inlet manifold but I dont know what.
Any suggestions would be appreciated coz I'm a bit stuck.
Thanks.
Sparkyhttp://i825.photobucket.com/albums/zz180/Drac0nyx/13032010065.jpg
General Baxter
13-03-10, 04:40 PM
what engine ?
sorry, its an E16SE Nova GSI H reg
novalicous
13-03-10, 04:42 PM
e16se?
the wire with a spade conector is for the temp sensor
the other one plugs in down the back of the block not quite sure what it is tho lol
is the temp sensor down there aswell?
novalicous
13-03-10, 04:45 PM
its a little sensor with a push on conector about a 13mm iirc
is this the temp sensor? if it is the blue spade must be for something else.....http://i825.photobucket.com/albums/zz180/Drac0nyx/13032010066.jpg
on the bottom of the inlet manifold there will be a place for the spade connector to go back onto.
General Baxter
13-03-10, 05:07 PM
the one with the plug will be the ecu temp sensor, the one with the spade will the the dash temp sensor
novanova636
13-03-10, 05:30 PM
Blue spade goes on the back of the inlet. Closest to the bulk head. It will feel like a large pin head. Its for the temp gauge in the dials. The other does look like it plugs onto the back of the block. Kinda below where the other cable goes
Ok, I found where the plug goes on the back of the block but not where the blue spade goes, could it be something that I inadvertently took off when I was painting the inlet?
The only place that I could see it going is here:-
http://i825.photobucket.com/albums/zz180/Drac0nyx/13032010068.jpg
Sorry for being stupid........
pikey1986
13-03-10, 06:30 PM
any chance you could re-size the pic or take one from a bit further away pls, its a bit too big
novalicous
13-03-10, 06:48 PM
the blue wire with the spade connector goes on this(which you said you broke only a couple of quid from motor factors)
http://i825.photobucket.com/albums/zz180/Drac0nyx/12032010058.jpg
I got a new one of these, but there isnt anywhere to connect a spade onto it
novalicous
13-03-10, 07:04 PM
it pushes over the top
the bit that broke of if you understand lol
like so
http://i33.photobucket.com/albums/d96/craig_johnson_/untitled-3.jpg
lol I understand, cheers!
Great Diagram!
More respect to you!
You can see my new temp sensor in my last pic
I gotta spread the respect around b4 I can give it to you again :( wonder how I got -24 respect, maybe too many stupid questions, but I'm sure I've always been polite.
Cheers for that, only minus 6 now, not long to go till I'm in the green! :)
novalicous
13-03-10, 07:36 PM
:d:d:thumb::thumb:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.