Nova SR oil pressure sender

[mk1nova_rich]

Just been reading that an SR should have two wires coming out of the sender...

Currently i havn't got any - where do these wires go/come from and what colours are they?

Thanks

[Southie]

If you have an oil gauge that has a light on your dials then you will have one of these which has one wire too it.

http://www.auto-car-parts.net/uploads/product/20061118015546628003.jpg


If you have a needle gauge then you will have one of these twin senders. This will need an extra wire that runs to the dials if you've got the normal light version of the dials.

http://www.auto-car-parts.net/uploads/product/20061118020747628006.jpg

[mk1nova_rich]

i have the SR 6 dial clocks so have the needle gauge. Will these wires already be in the loom? I have the blue wire that goes onto the spade fitting at the back of the gauge, is the other wire in the 12 pin??

[Southie]

You will be able to connect the single wire spade connector but you'll have to run a NEW wire to the back of the clocks if its not there, that's what I had to do anyway as I'd converted my clocks from the standard non rev counter ones.