View Full Version : v pulley help
i had a v pully laying around the garage and on the 20.l 8v engine it had one of them flat belt pulley. so i took it off and went to put put the v pulley and the bolts dont line up.
can i just drill the v pulley? or can i buy a belt that will go on to the
flat belt pulley to the alternator.
napalm_27
05-03-10, 12:41 AM
erm you've lost me abit there
your trying to put a v pulley set up on to go in the nova
is it going on a 2.0 or a small block..?
yes mate its going to go on the 2.0 engine
It only goes on in one position - the holes are offset so that the timiming marks line up etc..
Keep turning it and trying in different positions - it should go on...
it will not go on the bolts holes are way to small
Jon_nova1
05-03-10, 11:17 PM
if its just the bolt holes are too small then drilling the holes bigger will be fine as the balance won't be lost, just make sure everything else is right, or else you may render is useless if you find you can't use it anyway
ill take some pics tomorrow but its allready been driled
got some pics but today i found another one that would fit the v pulley but the tooths are diffrent to the cam and water pump :(
but from the pics you can see what i meen
http://i339.photobucket.com/albums/n441/Gibbo21087/DSC01079.jpg
http://i339.photobucket.com/albums/n441/Gibbo21087/DSC01077.jpg
the one thats on the engine
http://i339.photobucket.com/albums/n441/Gibbo21087/DSC01075.jpg
the one that fits the v pulley
http://i339.photobucket.com/albums/n441/Gibbo21087/DSC01080.jpg
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.