View Full Version : e16 se plumbing
stevie78
20-02-10, 02:05 PM
Can anyone tell me where the coolent pipe below the rocker breather on the throtle body goes as i dnt have the hose thanks stevie
Can anyone tell me where the coolent pipe below the rocker breather on the throtle body goes as i dnt have the hose thanks stevie
I've never seen the point of it, intake charge heater :wtf: mine is blocked off and the hose that runs into it just hits a dead end, I need to look into blocking that off further down while the engine is out actually. It's not like it would even be for cold starts as the stat wouldn't be open and coolant would be cold when you're starting it!
stevie78
20-02-10, 02:46 PM
Do you know where its ment to go?
I've never worked it out tbh, mine was entirely plumbed up with no loose ends so I can only assume I was missing a T piece somewhere, most sensible place for it to would be either the solid coolant pipe on the back of the block or the nearest heater matrix hose, which would be the O/S I think.
stevie78
20-02-10, 11:09 PM
bttt
do you want to come up and have a look at mine? it would answer a lot of questions for you.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.