LET inlet -heater matrix pipe prob

[alan b]

right so ive never had this problem before but since taking my let out and putting it back in, the inlet is sitting closer to the matrix pipe, and is kinking it! i have shortened the pipe already, what in the name of jeepers is going on? my mounts are std ones silko'd up and have never had a prob with them b4 and conversion mounts are CAM ones

[krobinson]

Common problem really. I cut the heater matrix copper pipe back tight to the bulkhead, and then fitted the jublie clip on the inside of the firewall. It's given me plenty of clearance.

[danzel]

higher the rear engine mount a bit pal?

[krobinson]

Found a pic of mine Alan.

http://img.photobucket.com/albums/v37/keithrobinson/Nova%20Rebuild%202006-2007/P260308_1714.jpg

[The Simps]

Good fix that Keith. Liking it.

[alan b]

higher the rear engine mount a bit pal?

aye mite have a look at that tomoro when its on lift:thumb: cant hurt to raise it a little!

[alan b]

Common problem really. I cut the heater matrix copper pipe back tight to the bulkhead, and then fitted the jublie clip on the inside of the firewall. It's given me plenty of clearance.

so how did you get the clip on it? behind the dash? looks like the right job, aslong as the dash doesnt have to come outlol

[krobinson]

Good fix that Keith. Liking it.

Years (about 10 infact) of watching people convert cars means you can overcome the problems.

There's even things I did that i'd do differently if/when I do it again!

:thumb: