GTE/GSI servo vac pipe/connector.

[Nick J]

Hi guys.

As above please......GSI/GTE servo vac pipe and connector that plugs into the servo please. Apparantly these are slightly different to those found on the smaller servo'd models? Please let me know what you have.

Thanks, Nick.

[Nick J]

Bttt :)

[Nick J]

bttt :)

[sparkie1401]

nick, when i put the servo i got off you on the car it had no vacuum bung (i PM'd you) but my old one fitted ok (from the smaller servo)

i did however go get a few various ones from a scrapyard, vectra/mondeo seem ok

my servo was hissing the other day but it wasnt fitted correctly, ive now done this so ill fire her up tommorow see if its now ok (bearing in mind its the GSi servo with small servo bung)

vectra would be fine i think though

[Nick J]

nick, when i put the servo i got off you on the car it had no vacuum bung (i PM'd you) but my old one fitted ok (from the smaller servo)

i did however go get a few various ones from a scrapyard, vectra/mondeo seem ok

my servo was hissing the other day but it wasnt fitted correctly, ive now done this so ill fire her up tommorow see if its now ok (bearing in mind its the GSi servo with small servo bung)

vectra would be fine i think though

You know Ive never been in this position before so I was a lttle unsure...... Is it only the servo bung thats needed and the vac pipe connector is no different then? If so I actually need nothing as I have the bung!

Nick.

[sparkie1401]

keeping simple i think you'll be ok with the bung you have, im 99% sure i am, think mine was leaking as the plunger/seal that fits behind the M.Cyl into the servo was missing so i think the bung is fine

im running it up tommorow so ill pm you, and veccy ones are slightly bigger