1650 E16se information

[Plug]

Right i poped into a engine builders down by me today and asked about getting my engine rebored and i will require the size of the piston used in a 1650 rebore people..

+rep for the helpful

Joe

[Plug]

bttt

[Mike]

The "engine builder" should easily be able to answer this chap.

[mowgli]

its just an oversized piston and nothing special.....i'll have a look in my big boring piston book & let you know in a bit..

[philip]

dont know the cc, but i think a stock piston you can only get max 1mm oversize. 0.5 or 1mm then its aftermarket

[Plug]

hmm ok i went down to the only engine builder within 30 miles and he said he stays away from performace stuff but would be willing to help me out.

Only thing was he said i would need to find out what size pistons, Etc :(

might have to look furter afield as he wont do porting and polishing or gas flowing

[mowgli]

http://www.powercrazy.co.uk/index.htm

http://www.tjhmotorsport.com/Engine_gearbox.aspx

http://www.rallytechmotorsport.co.uk/engines.asp

http://www.apmotors.co.uk/


i found these few companies within a few seconds on google....

also ask these people for your local stockists.. http://www.elringparts.co.uk/ it will be very useful...

jimbo... let me ask you this....

just what are you after with your 1600 engine???????

ie. hp, usage.

then we can help.

with a few simple mods, you can be getting reasonable power, but what can you afford, and what is your experience level. a small block can be rebuilt on your bedroom floor, trust me, i've done it.

[mowgli]

just looked up in my great big boring piston book & a 1.00mm overbore gives about 1640cc