View Full Version : is this the part i need to twist to fit the drill? pic here
novah108gly
20-01-10, 01:32 PM
http://i898.photobucket.com/albums/ac183/novah108gly/PICT0123.jpg
seems you need a does of this
http://en.wikipedia.org/wiki/Common_sense
novah108gly
20-01-10, 01:40 PM
yhea would helplol no i just dont want to mess it up because i am ment to be selling it tomorow if all goes well
novah108gly
20-01-10, 01:42 PM
seems you need a does of this
http://en.wikipedia.org/wiki/Common_sense
and you need spellcheck its dose not does:thumb:
let_nova
20-01-10, 01:46 PM
seems you need a does of this
http://en.wikipedia.org/wiki/Common_sense
and one for you:thumb:
http://en.wikipedia.org/wiki/Spelling
meh im tired. plus its simply just a typo, not that i cant spell.
plus it wouldnt come up on spell check any way as does is a word, so cram it!!
novah108gly
20-01-10, 01:48 PM
and one for you:thumb:
http://en.wikipedia.org/wiki/Spelling
yhea thanks now back to the question is this the part i realy need to no
you are trying to adjust the gear linkage!!! that IS the gear linkage!!!
cant see the piccy but come on its really not that difficult. get the little black plug out (dont lose it as the entire gearbox oil contents WILL leave via there!!!!!!! I know from Benjis experience lol), rotate the ONLY MOVING PART NEAR IT!!!!!!!!!! :wall: and slip the drill bit in shen its in the right place
novah108gly
20-01-10, 01:52 PM
you are trying to adjust the gear linkage!!! that IS the gear linkage!!!
so its the right bit then? isnt this the selector fork? and thanks
the selector forks are within the gearbox so no its not
novah108gly
20-01-10, 01:53 PM
cant see the piccy but come on its really not that difficult. get the little black plug out (dont lose it as the entire gearbox oil contents WILL leave via there!!!!!!! I know from Benjis experience lol), rotate the ONLY MOVING PART NEAR IT!!!!!!!!!! :wall: and slip the drill bit in shen its in the right place
thanks:thumb:
novah108gly
20-01-10, 01:54 PM
the selector forks are within the gearbox so no its not
ok thanks i was confused because in haynes it says twist the selector fork:thumb:
brainsnova
20-01-10, 02:29 PM
where the shiney pin comes out the gearbox well twist the joint its connected to.
jimbob-mcgrew
20-01-10, 02:38 PM
u cant really mess it up, as nothing gets un-done at this stage, youll feel the drill bit slide in an extra bit as u move the linkage, then the linkage will be set in that rotated position untill you take the drill bit out when your finished.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.