View Full Version : Weber dmtl questions.
Hey peeps,
Can someone please tell me where i take the vac advance from? i have to take offs, front and rear?
What jets should i be running on a 1.3?
Which throttle cable do i need? my 1.2 one doesn't fit?
Can someone post me a good pic of one with the air filter removed?
:)
comptoncj
10-01-10, 06:55 PM
If you have two vac take offs use either I would have thought?
Royston
10-01-10, 07:09 PM
Use one and blank the other off;) , mine was prejetted, so don't know jet sizes:confused: sold it a few years ago now
post up jets you have got in.
post up jets you have got in.
Can they be seen without removing?
Also what throttle cable do i need? my 1.2 one doesn't fit!!!
probably one from a 1300, it depends what kit it was from!
Was off baxters old nova 1.4
Just tried an xe throttle cable, and it's too long, would a gte one fit?
u need a 1300 or 1400 one. not sure about the GTE, what is the end like
1.3/1.4SR cable
Barrel end type?
1.3/1.4SR cable
Barrel end type?
Yeah that's it, bugger i haven't got one! lol
jimbob-mcgrew
10-01-10, 10:25 PM
if you dont have one attached allready, you'll need an adapter piece that attaches to the base plate of the carb to hold the body of the 1.3/1.4 throttle cable.
Southie
11-01-10, 08:55 AM
Yeah that's it, bugger i haven't got one! lol
Would one from say a mountain bike brake cable fit? Not sure if the ends are quite the same :confused:
Found one in the shed!
One more question, where do i put the return feed? T it into the feed to the pump? or between the pump and the carb?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.