View Full Version : Help: Possible Project?!?
Olli2004
04-01-10, 08:43 PM
Hi Everyone,
Within the next couple of months I am going to start looking for a Nova to start a project.
I am looking for something thats going to be a slight challenge but thats not too rotten!
One of the questions I want to ask is Where can panels be bought for Novas now for example rear arch repair panels / slam panel under bonnet etc??
Whilst looking for a project where do they rot most?? I've had a few Novas already and this is where I know they rot so far:
-Boot floor
-Slam panel
-Rear arches
Any info would be great help.
Thanks. Oliver
everywhere lol
battery tray
inner arch
splash guard
inner wings
oppisite side to the battery
sills
arches
rear chassis legs
bottoms or doors
behind the rear struts
rear panel
front panel
bottoms of wings
and i had a really good look around one and i still bought a ****ter. if i was to buy one again. i would want both wings off, both bumpers off. and then i would still be poking
puss puss
04-01-10, 09:05 PM
everywhere lol
battery tray
inner arch
splash guard
inner wings
oppisite side to the battery
sills
arches
rear chassis legs
bottoms or doors
behind the rear struts
rear panel
front panel
bottoms of wings
and i had a really good look around one and i still bought a ****ter. if i was to buy one again. i would want both wings off, both bumpers off. and then i would still be poking
It has feelings! Ill make it live again :thumb:
i have a shell not to bad tbh fancy it
craig green
04-01-10, 09:14 PM
Me too. A GSi shell here, been saved already, but would benefit a panel or 2 & some fresh paint, if you fancy a challenge.
Ollie i have a shell at the minute that could be a good first project, im in lofthouse ,wakefield come have a look and see if its any good?
Same here :p probably a bit far though, still the challenge can be moving it for under £175! lol
As stated above...they'll pretty much rot everywhere. However the majority of it is repairable.
Beavers panel do non GM parts. I can't comment on the quality or fitting but i know they supply many parts.
Olli2004
05-01-10, 08:28 PM
People above messaged about the shells.
Thanks for the info on where to look for the rust and also about where I can get panels.
stewart_2004
05-01-10, 09:10 PM
Ive just stripped a mk 2 shell for repair and found rust at the bottom passanger side of the windscreen underneath the rubber. took windscreen out and a patch fell out. also removed dash and under there was bad aswell at top on other side of the bulk head.
Olli2004
05-01-10, 10:14 PM
Thanks Stewart for the info. Is there a repair patch / panel for this also?
Olli2004
06-01-10, 04:45 PM
My friend is breaking his 2 litre 16v corsa. The engine is damaged - the inlet valves are all bent and slight damage to top of pistons.
He has another engine which he was going to make 1 good engine out of them both but has given up. Both engines are in bits but he says I can have both engines with the M Tech conversion kit for £500.
Is this a good deal and can I use the conversion kit from his corsa with my nova?
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.