PDA

View Full Version : K&N filter 2e3 carb


Asa-James
03-01-10, 12:09 AM
How do people bolt these down? It's got the holes pre cut to bolt straight on to my carb but the bolts arnt long enough. Help!
Sloth
03-01-10, 12:30 AM
longer bolts??? a few lengths of threaded bar and some nuts? sticky back plastic and a yoghurt pot?
jimbob-mcgrew
03-01-10, 09:02 AM
fibre washers on the topside nuts will prob help seal it a tad better too :thumb:
Asa-James
03-01-10, 09:17 AM
Where do you get longer bolts from? I've checked eBay, halfords, b&q...
pikey1986
03-01-10, 10:25 AM
longer bolts??? a few lengths of threaded bar and some nuts? sticky back plastic and a yoghurt pot?:thumb:
Nova_Tek
03-01-10, 10:32 AM
How do people bolt these down? It's got the holes pre cut to bolt straight on to my carb but the bolts arnt long enough. Help!

What K&N bolt on are you using? As I asked whether or not a 1.2 Carb bolt on would fit the 2e3 carb. If you could let me know mate :thumb:
Mazz
03-01-10, 10:33 AM
Don't B&Q sell threaded bar?
Asa-James
03-01-10, 10:37 AM
What K&N bolt on are you using? As I asked whether or not a 1.2 Carb bolt on would fit the 2e3 carb. If you could let me know mate :thumb:


The 2e3 carb is bigger, a 1.2 bolt on would fit but you would need to make thebig hole in the bottom bigger
Nova_Tek
03-01-10, 10:43 AM
Ok. Which bolt on are you actually using?
Sloth
03-01-10, 01:14 PM
you need an old skool hardware shop or a bolt suppliers, try your yellow pages....