PDA

View Full Version : heater problem



shaneyboi35
18-12-09, 01:12 PM
ive tried everything, basiccly i have no heating and in theese cold months its getting on my t1ts, i have replaced the heater motor twice replaced the fuses and still nothing! it doesent blow even on 3, the only way the car gets warm is if i go down the motor way at 60 it eventually starts to warm up.
any ideas??

Timmy
18-12-09, 01:20 PM
water flowing though it right ? you have the blower open?
wired in right ?

Timmy
18-12-09, 01:21 PM
earth?

Nova_Tek
18-12-09, 01:23 PM
Matrix gunked up, air lock, leaves in the vent passages. The the actual blower motor spin properly?

Balley
18-12-09, 02:56 PM
Take the switch out, check its plugged in right (sounds silly but the plug sits in a holder which tends to break, mine did this so when I poped the switch back in the plug fell out the back! The switch just pulls out :D)

jimbob-mcgrew
19-12-09, 03:48 PM
^ i was gonna say myself, have u checked the switch, might be knakered

AlexW
19-12-09, 03:51 PM
Are you sure the cable is still on proper? They do fall off so the vent bit inside dont move thus only giving you half heat/none/only hot.

Does the temp gauge go up? Thermostat could be stuck open.