View Full Version : What cam with turbo conversion?
novalovingned
16-12-09, 09:43 PM
What cam should be run on a e16se turbo conversion? I have a 270 profile cam and a piper cam adjustable pulley, will that be any use. Or do i have to use the standard cam and pulley?
Any info would be great :)
A custom grind cam ideally.
If not, use the standard one.
A "good" NA cam doesnt make a "good" cam for a turbo engine
Nova_Tek
16-12-09, 09:53 PM
Unless its the XE inlet cam in place of the LET inlet cam :)
craig green
18-12-09, 04:08 PM
Ideally a turbo specific cam will have 'less' overlap between the inlet & exhaust valve openings.
I had a Courtenay (piper) mild cam on my turbo & it was fine, it seemed to produce full boost a tad earlier than when I re-fitted the std cam which seemed to make it a little slower to produce max pressure. I wouldnt call it lag, just a sensation I was feeling, however it did seem stronger & higher revving on the std cam. So I'd advise against using an aftermarket (costly) cam tbh. Keep the vernier though, you can set it up more accurately & get a few more bhp most likely.
Are you planning to run a decomp spacer or not?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.