wiring 6x9 to my headunit

[shanehandley]

can kenwood 220w 6x9 be wired straight up to the headunit without a amp if its a 4x50w headunit!if not what else does it have to be! :o

if they can be wired up how and where do u put wires does any1 have any diagrams of how this is done etc!

any1 who noes anything please could u pm me or reply on here thanks loads,

shane. :D

[wisewood]

i wired in some 200w 6x9's to my 4x50w head unit the other day mate.

no problem at all... sounds fantastic... i will take some pics of the wiring behind the head unit for you as soon as i get chance when its light if you want - its not hard at all.

[bigdee]

just connect the wires to the rear speaker wire output on head unit
should say in your manual, or is usually the blue or purple 1s i think

then run the speaker wire down passenger side, do this by undoing the sills bits of plastics (only a few screws) then run through to boot

and then connect +ve wire to +ve point on speaker etc

and also remember to connect the left speaker wires to left speaker etc

hope this helps

[whitey]

should say in your manual, or is usually the blue or purple 1s i think


COULD BE ANY COLOUR MATE!

[bigdee]

could be any colour your right

but read what i put and i said usually

which it is

OK MATE!

[whitey]

K then mate! BOW DOWN!