mikeoxford
25-03-03, 09:33 AM
the F13 gearbox going on my engine a sprocket has slipped.
within the differential casing there is four cogs right? the top one and bottom one are fine, the passenger side shaft sprocket is fine. but it appears the driver side sproket is missing.
after removing the geartbox sump and getting covered in red gearbox treacle oil :roll: :lol:
i found the sprocket and shim in the sump, nothing is damaged but its obviously fell out or been thrown out under load or summat
:?: question is without removing the gearbox from the car how can i get the bugger back in?
last resort will to swap the gearbox and take it back where bought it.
may end up doing this unless theres a solution?
within the differential casing there is four cogs right? the top one and bottom one are fine, the passenger side shaft sprocket is fine. but it appears the driver side sproket is missing.
after removing the geartbox sump and getting covered in red gearbox treacle oil :roll: :lol:
i found the sprocket and shim in the sump, nothing is damaged but its obviously fell out or been thrown out under load or summat
:?: question is without removing the gearbox from the car how can i get the bugger back in?
last resort will to swap the gearbox and take it back where bought it.
may end up doing this unless theres a solution?