just changed my altonator belt and can't find where a little black cable goes??

[Markyc]

This is a corsa b 1.2 8v SPI

when changing the altonator belt i knocked off a little black cable that is in a bunch of 5 with 4 brown cable.

The black has a spade connector on the end. I can't find where it goes back.

I fought it would just been an earth so i earthed it out on the end of a spring for the throttle (jsust because it stays on) and the temp went off the scale.


Can anyone help with where this cable goes so i can put my ine at reast with the temp gauge

[Adam]

Its for the temp gauge, goes on the sender next to no1 runner on the inlet manifold

[Benn]

Water temp? If so that's the gauge wiring, needs to be connected to the sensor (by the stat or on the inlet.

If not its the one that gos on the back of the alt, there's a small sunken cut out where it plugs in.

[Markyc]

Anyone got a picture as i can't find it

[Adam]

You cant miss it. Its on the inlet, near the alternator.

[Markyc]

well i realy can't find it so just earthed it out on the inlet and the gauge still goes off the scale.

Does it need to go on that exact point??

[Adam]

It needs to go to the sender yeah.

[Markyc]

right found it was being blind haha!! yer all sweet now

thanks adam have some rep :)

[Adam]

:)

[Balley]

it make slot on to a button type end rather than a spade if that makes sense

[Balley]

http://i818.photobucket.com/albums/zz102/balley77/temp.jpg

like this, dont laugh at my paint skills but hopefully you will get the hint

[Markyc]

http://i818.photobucket.com/albums/zz102/balley77/temp.jpg

like this, dont laugh at my paint skills but hopefully you will get the hint

lol lol

i got it sorted now but have some rep for effort :thumb:

[Balley]

cheers fella