View Full Version : clocks wiring
what do i need to do to put sr clocks into my 1988 mk1 1.2 merit ??
let_nova
29-11-09, 06:19 PM
plug and play. if you wamt the oil pressure guage to work you will need a 2 pin sender.
brainsnova
29-11-09, 06:20 PM
plug them in the run a wire if not taped up from the - side of the coil to the clocks and fit a oil pressure sender to the engine and run the extra wire if not taped up.
not worried about oil pressure but will the rev counter work if i" just plug it in " i will eventually make the modifications for the oil pressure gauge..
brainsnova
29-11-09, 06:46 PM
the rev counter wire iirc is a seperate spade conector on the clocks back so it might be taped to the loom near the clocks plug.
ohh ok and whats the best solution for the oil pressure then
brainsnova
29-11-09, 06:52 PM
use the oil pressure sender as found on the 1.3sr,gte, astra gte etc.
brainsnova
29-11-09, 06:56 PM
it looks like this http://www.vauxhall-car-parts.co.uk/acatalog/90337695N_1.jpg
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.