View Full Version : XE Head
ant_tay
20-11-09, 03:28 AM
can i use a LET head to put on my XE or does it have to be an XE head
unless you are turboing it, i can't see the point
Heads are identical apart from the cams so you can use either head.
ant_tay
20-11-09, 07:58 AM
unless you are turboing it, i can't see the point
the point is i need another head and there is one off a turbo going cheap atm
Lee H thank you thats the answer i needed
MattBrown
20-11-09, 09:58 AM
Isnt there an extra hole in the head-gasket? For the turbo oil feed?
Therefore an extra hole in block and head?
the point is i need another head and there is one off a turbo going cheap atm
Lee H thank you thats the answer i needed
you didn't put that you were looking at using one as a direct replacement part, so sorry for the misunderstanding
Isnt there an extra hole in the head-gasket? For the turbo oil feed?
Therefore an extra hole in block and head?
No, oil feed is on the back of the block.
ant_tay
20-11-09, 03:23 PM
you didn't put that you were looking at using one as a direct replacement part, so sorry for the misunderstanding
ok sorry i should have said thank you though
Isnt there an extra hole in the head-gasket? For the turbo oil feed?
Therefore an extra hole in block and head?
Turbo feed is fed straight out of the back of the block right by the oil pump
--ToM--
21-11-09, 10:03 PM
iv used a let head on my xe before its safe to do aslong as you use xe cams
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.