corsa servo with nova master cylinder

[dan23]

the nove master cylinders fit on the corsa servo

so i guess it will be ok to use it saves messing around with bias
has anyone else used it can you use the standard brake pipes or do they have to be remade ?

[The Simps]

does the upright reservoir fit too?

[AlexW]

It works fine, your need to do the brake pipes again.

Reservoir might need someway of keeping it nice and tight though.

[dan23]

It works fine, your need to do the brake pipes again.

Reservoir might need someway of keeping it nice and tight though.

whats the best way to keep it tight then?
sounds dangerous if its loose:eek:

[AlexW]

Its only presuming the standard rubber ring seal things arnt keeping it tight or as i found on a new master cylinder (ment to be good but was rubbish) it didnt hold the rubber rings proplery.

Cable ties work fine, as long as it dont leak theres no problem.

My reason for saying is the corsa master cylinders have tabs on them to hold plastic bits from the reservoir.

[L14MNP]

Cable ties FTW. The push on design is so dangerous IMO.

0mg firez!