View Full Version : Altenator cutout for xe
right so im basically assumming from the article that the chassis area by the strut top needs to be cut so it sits flush with the turret?
So -
1. Im going to cut along 3 sides down along then up.
2. Push the metal back and then ad 3 small pieces of metal to create the box section? again 1 doen each side and then 1 along the bottom of the box.?
is this how people normailly do it?
It may be easier to cut the entire shape out, take the lip off it, and weld the top edge to the seam under the turret.
16v Nova Kev
08-11-09, 04:20 PM
most people hammer the leg.
It may be easier to cut the entire shape out, take the lip off it, and weld the top edge to the seam under the turret.
hmmm ta for that mate
Pistol Pete
08-11-09, 05:17 PM
I hammered mine. IMO it looks neater.
16v Nova Kev
08-11-09, 05:36 PM
I hammered mine. IMO it looks neater.
amen brother :thumb:
Mine just had a slit cut in it, pushed back and then welded back up again. Plenty of room, can get belt off easily etc.
i cut the section out and welded pieces in, just make sure you go far enough back because mine is mm's off catching lol
turbo-boy
08-11-09, 10:35 PM
anyone one got any pics of the chassis leg cut and welded up as im doing the same thing to mine
novalovingned
08-11-09, 10:44 PM
Pictures needed. Cut out vs hammered in lol
See articles on how to fit 2.0 engine, some box section pics there
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.