x16xe engine loom, ecu + grey mk2 dash + glass

[g111mds]

Taken the decision to hang on to the nova and find the time to complete the project. I'm looking for the following at the moment:

- engine wiring loom, ecu (+chip), inlet etc for an x16xe engine. I have the bare engine (no inlet) and box and basically need the add on bits to complete.

- complete mk2 dash in grey including air vent ducting, switches (with plugs and some of the wiring), glovebox etc.

- non tint rear side glass and rubbers for 2 door hatch or alternatively full set of green tint (sr/gte/gsi) side and rear glass including rubbers for side windows.

Thanks

Jamie

[g111mds]

up

[Smurf-Xx]

Got two rear window glass but no rubbers. £10 collected.

[vessey]

got the dash and full set of glass from sri pm for more info

[General Baxter]

i have the engne loom!

no ecu or transponder tho

[mviboi]

i have a x16xel loom ecu and transponder + key if you are interested, pretty sure you can use this on a x16xe

[John]

I have a grey mk2 dash, £5.

[napalm_27]

iv got loads of glass sets here mate :thumb:

[g111mds]

Thanks for all the replys. Have managed to locate pretty much everything. Think its about time to start a project thread!

Thanks again, Jamie

[vaughanmc]

I have some glass in the hut mate if you fancy coming up for a look at it

Not sure if it's tinted or normal...