View Full Version : Scrapped 1.3sr for 1.2
Nova-Boy
14-03-03, 08:13 PM
I have got myself a 1.3sr for scrap. going to take the carb, inlet, alternator, full exhaust and instrument panel. should i take anything else??
Anyone got any info that may help me change the carb/inlet properly onto my 1.2 eg. porting head, fitting breather hoses, extra choke cables, throttle, air filter etc etc. Dont want to leave something important that i will need!!
Also What do i need from the sr to get all the instruments on the dash to work on my 1.2 eg.
oil pressure gauge (will i need a sender from the engine? where is it??)
rev counter (cable from coil or something??).
I have tomorrow to rip the car apart then it is getting crushed.
Does anyone want me to get anything off it for them??
Thanks for any help! I need it for tomorrow morning!
mikeoxford
14-03-03, 08:25 PM
NEW
www.nova-land.com > How To Guides > Engine > 2 Wire Oil Pressure Sender
thatll tell you everything you need to know
Nova-Boy
14-03-03, 08:25 PM
If anyone has any serious advice i have totally forgot to mention then please do e-mail me or text/ring me 07752219045. I am trusting you people with my number here!!
Its all happening tomorrow!!!
mikeoxford
14-03-03, 08:27 PM
www.nova-land.com > How To Guides > Engine > 2 Wire Oil Pressure Sender
i pulled my finger out and uploaded it especially for you!
courtenaynova
15-03-03, 12:23 AM
Is there anything you wont do to boooooost you post count. LOL!
:D
Thast wot im doing now. :wink:
Nova-Boy
16-03-03, 10:58 PM
Followed the guide as you said. There was no wire taped up or one in the dash for it so i ran a new one in :). I also did the same for the rev counter. It is all working fine now apart from the speedo is causing some suspicion.
Have a look on my other topic :?
PS. The size spanner for the old oil sender was a different size to the one in your guide :wink:
mikeoxford
16-03-03, 11:04 PM
PS. The size spanner for the old oil sender was a different size to the one in your guide :wink:
well
read the small print
:lol:
summat along the lines of erros omissions and whatever not authors fault so tough
and also "all information correct at time of going to press" :lol: they were the sizes i had........
mikeoxford
16-03-03, 11:04 PM
Is there anything you wont do to boooooost you post count. LOL!
:D
Thast wot im doing now. :wink:
i goto great lengths for our nova community
i mean cumon not everyne rebuilds there engine three times in a month so they can fotograph every little defect to show people :lol:
Nova-Boy
16-03-03, 11:25 PM
I was only nit picking.
Very greatfull for the help mike. Your guides are very usefull and i wouldn't have had a clue without your help
:wink:
mikeoxford
16-03-03, 11:42 PM
:lol: brown nose :lol:
dikharvey
17-03-03, 12:33 AM
Central locking motors, loom and relay? Bucket seats. Anti roll bars. I did the same a while ago!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.