How to plumb in a brake bias valve?

[stevei]

can anyone doodle me a diagram so i know how to plumb in a brake bias valve? I might fit a hydrolic handbrake at the same time, but we'll see 'cause i'll do a rear disc conversion aswell.

bias valve looks like this
http://i.ebayimg.com/11/!BccnEl!!2k~$(KGrHqYH-EQEqv,dywINBK0iN8GhTQ~~_12.JPG

Mine runs wilwoods upfront and a GTE master cylinder if this matters

cheers muchley

ste

[Benn]

You'll need to be running one line to the rear, Then where ever you want the adjuster to sit you'll need to cut in to the line, fit new fittings to sure in to the adjuster.

[stevei]

that sounds easy enough. so you join the rear lines and run a single line into the car, into the bias valve and then split the line to both the rear brakes.

what about the hydrolic handbrake?

ste