solid xe mounts? MED any problems for anyone

[The_General_Chancer]

Just bought a set of billet engine mounts off MED in preston through ebay. They look spot on but dont fit, Im using a chris astley kit with the full stregthning kit as well.

Drivers front mount is around 8 to 10mm thick and wont let mount line up and the front gearbox mount is 16mm to short?:confused:

Any one tried these?

Or could i have been sent the wrong kit?

Are they a good company to deal with after you have paid your £129 to them?

link to item http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=220483324677&ssPageName=STRK:MEWNX:IT

cheers :thumb:

[Mazz]

They a pain in the **** to fit, i've used the Chris Astley set and they were ok..

See here, and my post

http://www.pngclub.com/forum/showthread.php?t=131464

[The_General_Chancer]

the engine is mounted agin using the standard one now it sits perfectly level etc. I only wanted to change the mounts as there is loads of movement under heavy load. So whats the best option new mounts from someone else?

rich

[novalicous]

i tiger sealed up all the rubber parts on my mounts bit of a bodge but doesn.t move an inch lol

[Tim]

mine went in ok, just the rear gbox mount gave a bit of a fight, a two hour fight, but eventually managed to get the bolt in. looking back now i have the front drivers mount set to high, so im thinking that maybe if i had that one in the correct hole then the rear mount may have gone in the way it should???