alan b
23-09-09, 07:53 PM
right so i was setting my boost the last day, and when i went upto .9 bar i got a flash code, lambda signal low, so i popped over to a mates to get his wideband(which i no is accurate) now so we set off again and the wide band read around 12:1 on full boost and wasnt lean anywhere in the rev range in any gear, yet the light flashed for the same reason, ive now set it to 1.1-1.2 bar and its reading 13:1 on full boost, light is still flashinglol so i checked it with a different wideband and got the exact same readings, so my question is, is it safe to run it like this? if the ecu thinks its lean? also worryingly im running a std 3 bar regulator. with phase 2 chips rst plugs and an exhaust. cheers guys