PDA

View Full Version : 14nv charged?


napalm_27
17-09-09, 04:29 PM
could it be possible to charge one?
was thinking about using bike carbs with a sealed intake and charging it with a eaton like baxters loon
as the engine is low compression thought it would take nicely to it may get a e16se head and bolt it on and run stand alone with the injection
helpful comments please :thumb:
Nick
17-09-09, 04:31 PM
Bikes carbs will do a fail .
Stuart
17-09-09, 04:31 PM
why would you post this in mupper corner? moron

and yes the minimal thought youve put in is enough to make a start on it.
napalm_27
17-09-09, 04:39 PM
wont the carbs hold the pressure?
Nick
17-09-09, 04:42 PM
Stu seems to think so, i would have thought they will have issues.
Stuart
17-09-09, 04:44 PM
if they are in a sealed box (good luck with that by the way) then there is no reason why they shouldnt work.

bike TB's + megasqurt would work.
or simply stick the 16se head on and use the std ecu etc and bodge a rising rate FPR on
napalm_27
17-09-09, 04:45 PM
well most bike carbs if not all from bigger bikes have a plastic top to them so if they would fail id imagine that they would fail from say 'blowing there tops off'
napalm_27
17-09-09, 04:46 PM
if they are in a sealed box (good luck with that by the way) then there is no reason why they shouldnt work.

bike TB's + megasqurt would work.
or simply stick the 16se head on and use the std ecu etc and bodge a rising rate FPR on

id most likely mould one out of fibreglass so that it wouldnt have any holes in from such likes of my half experienced welding
therealnovaboy
17-09-09, 04:48 PM
if you mean bike TB's insted of carbs then yes it would work with the right pullys.
Stuart
17-09-09, 04:48 PM
and getting the throttle cable in (leak free)? ;)
Andy
17-09-09, 04:49 PM
It isnt happening is it
Nick
17-09-09, 04:52 PM
+ Good luck finding anyone to buy/swap parts with ha . Have some more Neg
napalm_27
17-09-09, 04:52 PM
and getting the throttle cable in (leak free)? ;)

id mould pipes into the box so i could us silicone hose on each side to keep it leak free and then the carbs are easy to access for such as throttle cable etc
Southie
17-09-09, 04:56 PM
mmm bike carbs ey ;)
napalm_27
17-09-09, 05:02 PM
well just sourced me a 16se head etc
Spudly
17-09-09, 05:03 PM
mmm bike carbs ey ;)



OI!!!!!!!!!!
napalm_27
17-09-09, 05:14 PM
would it benefit from a decompression plate or will the 16se head lower the cr abit more??
Nick
17-09-09, 05:18 PM
This thread will benefit from more Neg Rep.
Southie
17-09-09, 05:50 PM
OI!!!!!!!!!!
Get your finger out then lol
Stuart
17-09-09, 07:45 PM
id mould pipes into the box so i could us silicone hose on each side to keep it leak free and then the carbs are easy to access for such as throttle cable etc


and the cable itself leaking... ;)

again good luck lol