PDA

View Full Version : Air/Fuel Ratio Gauge... No Signal Wire? XE


ST-eater
16-09-09, 07:31 PM
Hi all..

Ive managed to get hold of a funky air/fuel ratio gauge...

Upon looking into wiring it, i have 3 wires... One 12v, one 12v(-) and a signal wire, which attatches to a lambda in the exhaust...

Only problem is i dont have a lambda lol. Running the early XE loom which doesnt have a lambda in the wiring loom.

Is there anywhere else i can get the reading from, or is it just better to forget fitting it?
Stuart
16-09-09, 09:05 PM
sell it

even if you did have a lambda equipt XE it would only read rich or lean all the time as the XE ones are the switching type.
Adam
16-09-09, 09:08 PM
Need a wideband sensor and controller to get a meaniful reading.
garethcolley
16-09-09, 10:35 PM
mini cooper s lamda should sort it.
Stuart
17-09-09, 08:52 AM
and the controller for it would be where ;) lol
craig green
17-09-09, 10:40 AM
Narrow band FTL.
ST-eater
18-09-09, 01:10 PM
haha its on ebay now, cheers guys
burgo
18-09-09, 02:03 PM
http://14point7.com/Widebands/JAW_1_041/JAW_1_041.htm

£80 ;)
Stuart
18-09-09, 05:14 PM
http://14point7.com/Widebands/JAW_1_041/JAW_1_041.htm

£80 ;)


ohh a new version.... Might get that, although I still need to use the older one I havent touched lmao
Adam
18-09-09, 06:04 PM
Same here /\ lol
Got it fully built and working but cba buy a sensor lol
Stuart
18-09-09, 06:23 PM
Same here /\ lol
Got it fully built and working but cba buy a sensor lol


sounds familiar :d

see if we can blag a deal for two? lol
burgo
18-09-09, 10:14 PM
well i for one recommend the jaw kits. we fitted one to my mates celica and it works pukka