View Full Version : Yipee!
Just got my car back from Hi tec after having it setup. Came back at 183bhp 175lbft torque! am well pleased for a standard engine with the carbs bolted on!:thumb: :d :d :d :d
cams will be next mate but im unsure which ones to go for!?
Southie
02-09-09, 09:28 PM
Bike carbs FTW wooooo :)
craig green
02-09-09, 09:59 PM
Good result really, does it drive, start or run as well as it used to on the motronic/SFI?
Good result really, does it drive, start or run as well as it used to on the motronic/SFI?
Well, the ignition timing was out before it went in so didnt start anywhere near aswell as the SFI but seems ok now. Low down about 500 -1500rpm say in traffic it burbbles on first accelertaion abit where the SFI would be fine. I do belive that as a daily it would piss you off lol but seems a hell of a lot torqueier (spelling) and does pull well but doesnt rev much past 6k. Im really pleases with the gains and how easy a conversion it is:thumb:
General Lee
03-09-09, 08:23 AM
Blimey thats a good result especially as you were only hoping for anything over 160. Good work fella.
Good figure that - although the torque seems a little high - but then what do I know.
Similar bhp to Corsakid's on T45s...
;)
GRUNT 16V
03-09-09, 10:30 AM
How Long Before It Goes Bang ????????lol
Good figure that - although the torque seems a little high - but then what do I know.
Similar bhp to Corsakid's on T45s...
;)
tbh mate the torque is a rough estimate ruleing off the top line on the torque graph so could be a little less:thumb:
tbh mate the torque is a rough estimate ruleing off the top line on the torque graph so could be a little less:thumb:
I see - as long as it goes well, thats all that metters! :thumb:
dj_wudgey
04-09-09, 06:25 PM
i love 40/45 ect they sound the f*cking nuts hence there's a set waiting to go on the sr!! not bad any way mate!!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.