Paul
01-09-09, 03:39 PM
LET Inlet manifold, modified to take a Cav V6 (3") Throttle Body. The standard LET TB fitting has been cut off, and a plate has been welded on to accept the Cav V6 TB to sit vertically. The mount for the throttle cable is on there, basically you just bolt on the TB and you're away! It is based on a traction control manifold so the throttle body sits lower and you can still close the bonnet ok.
£70 ono
Custom LET inlet, one of speckys old one's, I have had quite a bit of welding done on this, and proper mount made for a nice good brace. £220 ono
PICS TO FOLLOW FOR BOTH OF THESE /\
Aerocatch's, new in sealed packet. they are non locking flush fit (mount on the surface o the panel, not underneath)
£35 posted ono
ARP Rod bolts for Steel H section rods, used but in good condition, all mesure up identically £30 posted
XE/LET Cam Cover £10 plus postage
Cam pulleys, early and late £10 per pair plus postage
XE Metal Plug Cover £25 posted
More to follow...
Paul:thumb:
£70 ono
Custom LET inlet, one of speckys old one's, I have had quite a bit of welding done on this, and proper mount made for a nice good brace. £220 ono
PICS TO FOLLOW FOR BOTH OF THESE /\
Aerocatch's, new in sealed packet. they are non locking flush fit (mount on the surface o the panel, not underneath)
£35 posted ono
ARP Rod bolts for Steel H section rods, used but in good condition, all mesure up identically £30 posted
XE/LET Cam Cover £10 plus postage
Cam pulleys, early and late £10 per pair plus postage
XE Metal Plug Cover £25 posted
More to follow...
Paul:thumb: